Embroidery Machine Communication Module - Husqvarna Viking Designer Ruby Deluxe User Manual

found, you will be informed that drivers have been
removed and that the computer must be restarted.
Click OK to restart the computer. Installation will
resume after the computer has restarted.
8. At the end of the installation, you will be prompted
to connect your embroidery machine. Click Finish on
the last page. Leave your 5D
software CD in your computer.
9. The Found New Hardware wizard will appear. Select
'No, not at this time' on the first page, then click
Next. Select 'Install the software automatically', then
click Next. A warning will appear that the drivers are
not signed. This is normal and should not be a cause
for concern. Click Continue Anyway, and the driver
installation will complete automatically.
how To laUnCh The prograMs
shortcuts on the desktop
1. Double-click on the Shortcut to the 5D
System program folder. A list of the programs appears.
2. Double-click on 5D
5D Configure to launch it.
™
Alternatively use the Start Menu to open modules under
Start, All Programs, 5D
eMbroidery MaChine
CoMMUniCaTion ModUle
The Embroidery Machine Communication module must
be active ( or
with your computer. The icons are found in the lower
right corner of your computer screen. If the Embroidery
Machine Communication module is not active, it may be
started from the Send tab of 5D
viewing and printing pdf guides
To find all the Reference and Sample guides for your 5D
Embroidery System software, go to Start, All Programs,
5D Embroidery System then choose Reference guides
™
or Sample guides. Choose the relevant folder, then select
the desired PDF guide. Double-click on the desired name
to launch the relevant .pdf file if you have Adobe Acrobat
installed on your computer. To install the Acrobat Reader,
insert the 5D Embroidery System CD and select that
™
option from the menu that appears.
how To UpdaTe yoUr MaChine
Be sure to consult the web site at www.husqvarnaviking.com
and/or your local authorized HUSQVARNA VIKINg
dealer for updates and upgrades for your machine and
User's guide.
You can update your machine using the USB embroidery
stick or the USB cable packed with your machine (P/N:412
62 59-04).
2:12
Embroidery System
™
Embroidery
™
Organizer, 5D QuickFont or
™ ™
Embroidery System.
™
) to use your embroidery machine
Configure.
™
Updating instructions
1. Open 5D Configure and connect your machine to
™
your computer.
2. Follow the instructions on the screen to update your
machine.
Updating using the hUsQvarna viking
embroidery stick
• go to the HUSQVARNA VIKINg
www. h usqvarnaviking.com to find information about
available updates.
• Follow the update wizard to prepare your USB
embroidery stick for the update.
• To set your machine in update mode, press and hold
the Needle Stop Up/Down button and the Sensor
Foot Up button while turning on the machine. Follow
the instructions on the sewing machine screen to
update from your USB Embroidery stick.
• When the update is completed the machine will restart
automatically.
™
®
Usb
®
web site at
®