Function Buttons In Embroidery Stitch-Out - Husqvarna Viking Designer Ruby Deluxe User Manual

Speed - and +
(Monochrome)
speed + and -
All stitches in your machine and each hoop size have a pre-
set, recommended sewing/embroidery speed.
Press Speed + or Speed - to increase or decrease the
maximum allowed sewing/embroidery speed. When not
sewing/embroidering, press Speed and a pop-up message
on the screen will indicate the speed setting. You can set the
speed by touching the slider in the pop-up message. If you
change the speed setting while sewing/embroidering no
pop-up message will appear.
When sewing with metallic threads, or when sewing on
delicate fabrics, lower the speed for optimal results.
sTop (MonoChroMe)
Press STOP to eliminate stops for color changes to create
monochrome embroidery.
fix (basTe)
Press FIX to baste an outline of the embroidery design
area to baste the fabric to the stabilizer.
sTarT/sTop
Press this button to start and stop the machine sewing
or embroidering without using the foot control. Press
START/STOP to begin and press again to stop.
reverse
Reverse has no function in Embroidery Mode.
8:10

fUnCTion bUTTons in eMbroidery sTiTCh-oUT

STOP
FIX
(Baste)
Start/Stop
Reverse
Sensor Foot Up and Extra Lift
Sensor Foot Down and Pivot
seleCTive Thread CUTTer
The Selective Thread Cutter automatically cuts the threads
and raises the presser foot. At the end of a color block the
top thread only is cut. When the design is finished, both
top and bobbin threads are cut automatically.
needle sTop Up/down (TriM posiTion)
The machine will move the hoop forward, towards you, for
easy thread trimming.
sensor fooT Up and exTra lifT
Press the Sensor Foot Up and Extra Lift to lift the presser
foot to Up position. Press once more and the presser foot
will raise to Extra Lift, to make it easier to insert or remove
the hoop.
sensor fooT down and pivoT
The presser foot is lowered automatically when you start
sewing/embroidering.
Press Sensor Foot Down to lower the presser foot into the
Embroidery "float" position.
Selective Thread Cutter
Needle Stop Up/Down
(Trim Position)