Husqvarna Viking Designer Ruby Deluxe User Manual page 102

Check needle Thread
The machine stops automatically if the needle thread runs
out or breaks. Re-thread the needle thread, close the pop-
up message, go back a few stitches using the Step Stitch-by-
Stitch control and start embroidering again.
embroidery is finished
A pop-up will appear when the embroidery is finished.
Touch OK to get back to your design and stay in
Embroidery Stitch-Out.
Change to Cutwork needle (optional accessory)
Some cutwork designs can be stitched out using the
optional accessory HUSQVARNA VIKINg Embroidery
®
Cutwork Needle Kit, (P/N 920268-096). These designs are
marked with a cutwork needle symbol in the DESIgNER
RUBY deLuxe Sampler Book. When the machine stops
™
and this pop-up message is shown, insert the corresponding
cutwork needle. Touch OK and press the Start/Stop button
to resume.
Note: These cutwork designs can also be stitched out without the
cutwork needles, but will then have to be cut manually.
Main motor overloaded
If the machine is blocked when embroidering, the main
motor can get overloaded. When the main motor and
power supply are no longer overloaded, the OK button will
be enabled. Touch OK to resume embroidering.
raise needle
When the needle is lowered with the handwheel to check the
needle position on the fabric, a pop-up message is displayed
when trying to adjust the hoop position. Check the box to be
able to fine tune the hoop position with the needle lowered.
Note: Make sure the needle is above the fabric to prevent damage to
the needle and fabric.
Note: The warning cannot be disabled when the needle is below the
stitch plate.
8:12