Messages And Error Messages - Roland V-Drums TD-20X Owner's Manual

Messages and Error Messages

This section lists the messages (error messages) that the TD-20X produces and explains the meaning of each message,
giving you the appropriate action to take.
fig.99-001-error-accept.eps_70
When an indication of "ACCEPT" is shown above the
[F5] button as in the figure, pressing that button will
close the message window.
Error Messages
Message
Backup Battery Low!
System Initialize
MIDI Communication
Error!
System Error!
Measure Maximum!
Step Maximum!
Data Overload!
Not Enough Memory!
No Card!
No Space!
No Data!
Unsupported!
Unformatted!
Card Damaged!
BULK DUMP
Checksum Error!
BULK DUMP
Receive Address Error!
BULK DUMP
Receive Data Error!
BULK DUMP
Receive Time Out!
126
Meaning
The internal backup battery of the TD-20X (a battery that
maintains data in the user memory) has run down.
Data in the TD-20X's memory may be corrupted. The TD-
20X's internal backup battery (the battery used for saving
User memory data) is fully drained; internal data has been
lost.
It is possible that the power has been turned off for the MIDI
device connected to the TD-20X's MIDI IN connector.
A problem has occurred with the internal system.
The maximum number of measures that can be recorded to
one pattern has been exceeded; no further recording or
editing that adds measures can be carried out.
The maximum number of steps that can be recorded to one
chain has been exceeded; no further editing that adds steps
can be carried out.
Pattern contained an excessive amount of data, and as a
result could not be output successfully from MIDI OUT.
Pattern recording or editing could not be carried out
because there was not enough internal memory.
No card is in the CompactFlash card slot.
There are no empty space on the CompactFlash card.
No data you request on the CompactFlash card.
A card the size of which is not supported by TD-20X has
been inserted.
A card the format of which is not supported by TD-20X has
been inserted.
The data stored on the card has been corrupted.
The checksum value of a system exclusive message was
incorrect.
The receive address of a system exclusive message was
incorrect.
A MIDI message was received incorrectly.
The interval in receiving system exclusive messages were
too long.
Action
Contact your dealer or a nearby Roland service center to
have the battery replaced.
Contact your dealer or a nearby Roland service center to
have the battery replaced. Follow the messages appearing
on the screen to carry out Factory Reset (p. 114); you will
then be able to use the unit temporarily.
Check the power of the connected MIDI device.
Contact your dealer or a nearby Roland service center.
Delete unneeded measures from the pattern being
recorded or edited (p. 88).
Delete unneeded steps from the chain being edited (p. 43).
Try eliminating a part that has too much data.
Try deleting patterns that are no longer needed (p. 88).
Insert a CompactFlash card.
Delete unneeded data (p. 94).
–
Cards supported by TD-20X are 3.3 V CompactFlash cards
with the capacity of 16 MB to 4 GB. Check the card.
Format the card (p. 94).
Format the card (p. 94).
Correct the checksum value.
Correct the receive address.
If the same error message is displayed repeatedly, there is
a problem with the MIDI messages that are being
transmitted to the TD-20X.
Make the interval of the data shorter.