Copying A Pattern [F1 (Copy)] - Roland V-Drums TD-20X Owner's Manual

Chapter 6. Recording and Editing Patterns—Sequencer

Copying a Pattern [F1 (COPY)]

Copy the pattern as is to the user patterns.
fig.07-Cpy1
1 2 3
Src
1 2 3
Dst
You can copy selected measures of a part or pattern. Unlike
copying an entire pattern, settings such as instrument and
part volume etc. will not be copied.
fig.07-Cpy2
1 2 3
Src
1 2 3
Dst
1.
In the "PATTERN EDIT" screen, press the [F1
(COPY)] button.
The "PATTERN COPY" screen appears.
fig.06-009-ptn-copy.eps_70
2.
When you want to copy selected measures or part,
press the [F4 (MEASURE)] button.
The "PATTERN COPY MEASURE" screen appears.
fig.06-010-ptn-copy-meas.eps_70
3.
Use the [CURSOR] buttons to select the parameter.
4.
Use the [-] [+] buttons or the [VALUE] dial to select
the pattern, part, and measures.
Pattern
Copy-source
Src
pattern
Copy-
Dst destination
pattern
86
4 5 6 7 8
4 5 6 7 8
4 5 6 7 8
4 5 6 7 8
Part Measure
Measures to be copied
Copy-source
(First Measure–Last
part
Measure)
Copy-
First measure of the
destination
copy-destination
part
5.
Press the [F5 (COPY)] button.
The confirmation screen appears.
fig.06-011-ptn-copy-conf.eps_70
To cancel, press the [F1 (CANCEL)] button.
6.
Press the [F5 (EXECUTE)] button.
• If the number of measures in the copy-source pattern
and the copy-destination pattern differ, the number of
measures in the copy-destination pattern may increase
or decrease according to this difference.
• When "ALL" is specified in "Src part," then only "ALL"
may be specified in "Dst Part." Additionally, if other than
"ALL" is specified in "Src part," then "ALL" cannot be
specified in "Dst Part."
• When copying between drum kit parts and percussion
parts or backing parts, copy takes place in accord with
the predetermined correspondence between note
numbers and trigger inputs. Only note numbers
assigned to trigger inputs will be copied.
For more on note numbers and trigger inputs, refer to
"Note Number (Factory Settings)" (p. 137).