Removing The Optional Two-Port Ethernet Adapter - IBM System x3550 M3 Type 4254 Problem Determination And Service Manual

4. Replace the cover (see "Installing the cover" on page 174).
5. Slide the server into the rack.
6. Reconnect the power cord and any cables that you removed.
7. Turn on the peripheral devices and the server.

Removing the optional two-port Ethernet adapter

To remove the Ethernet adapter, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices and disconnect all power cords; then,
3. Remove the PCI riser-card assembly (if installed) from PCI riser connector 1
4. Grasp the Ethernet adapter and disengage it from the standoffs and the
on page 167.
remove the cover (see "Removing the cover" on page 174).
(see "Removing a PCI riser-card assembly" on page 233.
connector on the system board; then, slide the Ethernet adapter out of the port
openings on the rear of the chassis and remove it from the server.
Chapter 5. Removing and replacing server components
217