The Rtp Settings - Cisco TelePresence Codec C90 Administrator's Manual

Cisco TelePresence System Codec C90 and Profile 65" Dual using C90
Contents Introduction

The RTP settings

RTP Ports Range Start
Specify the first port in the range of RTP ports. See also the "H323 Profile [1..1] PortAllocation"
command.
Requires user role: USER
Value space: <1024..65502>
Range: Select a value from 1024 to 65502.
Example: RTP Ports Range Start: 2326
RTP Ports Range Stop
Specify the last RTP port in the range. See also the "H323 Profile [1..1] PortAllocation"
command.
Requires user role: USER
Value space: <1056..65535>
Range: Select a value from 1056 to 65535.
Example: RTP Ports Range Stop: 2486
D14635.0 6 Profile C90 and Codec C90 Administrator Guide TC4.2, July 2011.
Copyright © 2010-2011 Cisco Systems, Inc. All rights reserved.
Web interface Advanced settings Advanced settings
The Security settings
Security Audit Server Address
Enter the external/global IP-address to the audit syslog server.
Requires user role: AUDIT
Value space: <S: 0, 64>
Example: Security Audit Server Address: ""
Security Audit Server Port
Enter the port of the syslog server that the system shall send its audit logs to. A user with AUDIT
rights is required to change this setting.
Requires user role: AUDIT
Value space: <0..65535>
Example: Security Audit Server Port: 514
Security Audit OnError Action
Describes what actions will be taken if connection to the syslog server is lost. A user with AUDIT
rights is required to change this setting.
Requires user role: AUDIT
Value space: <Halt/Ignore>
Example: Security Audit OnError Action: Ignore
Security Audit Logging Mode
Describes where the audit logs are recorded or transmitted. A user with AUDIT rights is required
to change this setting.
Requires user role: AUDIT
Value space: <Off/Internal/External/ExternalSecure>
Example: Security Audit Logging Mode: Off
54
Password protection
Format: String with a maximum of 64 characters.
Range: Select a value from 0 to 65535.
Halt: If the connection to the syslog server is lost for more than a few seconds, the system will
reboot and try to establish connection. If connection is restored, the audit logs are respooled
to the syslog server, and the system starts up again.
Ignore: The system will continue its normal operation, and rotate internal logs when full. When
connection is restored it will again send its audit logs to the syslog server.
Off: No audit logging is performed.
Internal: The system records the audit logs to internal logs, and rotates logs when they are full.
External: The system sends the audit logs to an external audit server.
ExternalSecure: The system sends the audit logs to an external audit server that is verified by
the Audit CA list.
Administrator guide
Appendices Contact us
www.cisco.com