The Conference Settings - Cisco TelePresence Codec C90 Administrator's Manual

Cisco TelePresence System Codec C90 and Profile 65" Dual using C90
Contents Introduction
Cameras Camera [1..7] Whitebalance Level
Set the whitebalance level. NOTE: Requires the Camera Whitebalance Mode to be set to manual.
Requires user role: ADMIN
Value space: <1..16>
Range: Select a value from 1 to 16.
Example: Cameras Camera 1 Whitebalance Level: 1
Cameras Camera [1..7] DHCP
Applies to cameras which supports DHCP. The Cisco TelePresence PrecsisionHD 1080p camera
supports DHCP. The camera must be connected to a LAN. When set, the command enables
support for SW upgrade of daisy chained cameras. It will enable the camera's DHCP function and
force start of MAC and IP address retrieval. Remember to reset the DHCP when the camera is no
longer connected to a LAN.
Requires user role: ADMIN
Value space: <On/Off>
On: Enable DHCP in the camera. The camera is automatically re-booted. After re-boot the
DHCP is started and the IP address will be retrieved. Run the commnand "xStatus Camera"
for result.
Off: Disable DHCP in the camera. NOTE: This setting should be applied when the camera is
not connected to a LAN.
Example: Cameras Camera 1 DHCP: Off
D14635.0 6 Profile C90 and Codec C90 Administrator Guide TC4.2, July 2011.
Copyright © 2010-2011 Cisco Systems, Inc. All rights reserved.
Web interface Advanced settings Advanced settings

The Conference settings

Conference [1..1] IncomingMultisiteCall Mode
Set the incoming Multisite call mode. The MultiSite feature allows participants from more than two
locations to join a meeting — by video and/or telephone.
Requires user role: ADMIN
Value space: <Allow/Deny>
Example: Conference 1 IncomingMultisiteCall Mode: Allow
Conference [1..1] AutoAnswer Mode
Set the AutoAnswer mode.
Requires user role: ADMIN
Value space: <On/Off>
Example: Conference 1 AutoAnswer Mode: Off
Conference [1..1] AutoAnswer Mute
Determine if the microphone shall be muted when an incoming call is automatically answered.
NOTE: Requires the AutoAnswer Mode to be enabled.
Requires user role: ADMIN
Value space: <On/Off>
Example: Conference 1 AutoAnswer Mute: Off
Conference [1..1] AutoAnswer Delay
Define how long (in seconds) an incoming call has to wait before it is answered automatically by
the system. NOTE: Requires the AutoAnswer Mode to be enabled.
Requires user role: ADMIN
Value space: <0..50>
Example: Conference 1 AutoAnswer Delay: 0
40
Password protection
Allow: Accept incoming calls to an already active call/conference. The incoming call will be
added to the MCU conference.
Deny: The system will not accept incoming calls when you are in a call. The calling side will
receive a busy signal.
On: Enable AutoAnswer to let the system automatically answer all incoming calls.
Off: The incoming calls must be answered manually by pressing the OK key or the green Call
key on the remote control.
On: The incoming call will be muted when automatically answered.
Off: The incoming call will not be muted.
Range: Select a value from 0 to 50 seconds.
Administrator guide
Appendices Contact us
www.cisco.com