Table of Contents
Advertisement
Quick Reference Guide
Selecting Beeper Volume
The scanner emits a short beep when it successfully reads a bar code. The volume of
the beep is changed by scanning one of the beeper volume bar codes in the LS7708
Product Reference Guide, or by using the Volume Control & Wakeup button on the front
of the scanner as follows:
Press and hold the button for approximately five seconds. The scanner cycles
1.
through three settings (low, medium, high), emitting a two-beep tone at each
setting.
To select a particular setting, release the button after the desired 2-beep tone
2.
is heard.
Beeper Definitions
The scanner communicates with the user by emitting different beeper sequences and
patterns. See the Standard Beeper Definitions table for beeper sequences that occur
during both normal scanning and while programming the scanner.
Beeper Sequence
Standard Use
3 short high beeps
Short high beep
4 long low beeps
5 low beeps
Hi-hi-hi-lo beep
Code 39 Buffering
Hi-lo beep
3 long high beeps
Power up.
A bar code symbol was decoded (if decode
beeper is enabled).
A transmission error was detected in a scanned
symbol. The data is ignored. This occurs if the
scanner is not properly configured. Check
option setting.
Conversion or format error.
RS-232 receive error on RS-232 host or RS-232
auxiliary port.
New Code 39 data was entered into the buffer.
Code 39 buffer is full.
Indication
11
Hide quick links:
Advertisement
Table of Contents
