Threading The Machine - Janome Memory Craft 10001 Instruction Manual

Janome MC10001 Instruction Manual
4
6
www.aaasewing.com
2
3
5

Threading the Machine

Raise the Presser Foot Lifter. Press the
Up/Down Needle Button to raise the needle
to its highest position.
Hold the upper thread with both hands as
shown and place it downward into the
Slit.
1
Draw the thread around the Thread Guide
following the solid yellow line as shown in
the diagram.
1 Slit
2 Thread Guide
Then draw the thread down around the
Check Spring Holder.
Firmly draw the thread up to the Take-up
Lever and down into its eye from the right to
the left.
3 Check Spring Holder
4 Take-up Lever
Then draw it down through the Lower
Thread Guide.
Slide the thread behind the Needle Bar
Thread Guide on the left.
5 Lower Thread Guide
6 Needle Bar Thread Guide
Thread the needle from front to back by
hand or use the Automatic Needle Threader.
NOTES:
• Memory Craft 10001 is equipped with
a thread breakage sensor.
If the machine is run without thread, it
automatically stops after about 10
strokes.
14
MC10001 Owners Manual/ User Guide