Eon Function - JVC CA-TD77R Instructions Manual

PTY SELECT PTY SELECT
– +
PTY SEARCH
EON
ON/OFF
TA/NEWS
/INFO
24
3. Press the PTY SELECT –
button to choose a PTY.
• The programme type display changes with each press of the PTY SELECT button as shown
below.
+ Press the PTY SELECT –
Ô TRAFFIC Ô NEWS Ô INFO Ô POP M Ô ROCK M Ô M.O.R. M Ô
LIGHT M Ô CLASSICS Ô OTHER M Ô AFFAIRS Ô SPORT Ô EDUCATE
Ô DRAMA Ô CULTURE Ô SCIENCE Ô VARIED Ô
Press the ¡ ¢
4. Press the 3 PTY SEARCH
While the search function is running, the selected programme type and "SEARCH" alternate on the
display. The preset number also change.
Once the station which is broadcasting the selected PTY (Programme Type) is located, searching will
stop. Then the station name (if PS code is being sent) will be indicated and the broadcast will commence.
The Display will stay blinking for 10 seconds from the end of the searching function. If you press the
PTY SEARCH button again during this period, search for the same PTY (Programme Type) will restart.
The PTY Search function is completed when the indicated preset Number changes from blinking to
continuously lit.
o If a station broadcasting a selected PTY( Program Type) cannot be found, "NOT" and "FOUND" are
displayed alternately on the display after the Unit has searched through the preset numbers. The Unit
will then return to the station to which it was tuned prior to the start of the PTY Search.
To cancel a PTY Search operation, press the PTY SEARCH button. "PTY" and "SELECT" are
displayed alternately on the display for a few seconds, then the display return to the screen that was
selected before PTY SEARCH was displayed.
Note: PTY Search can be used even while AM (MW/LW) broadcasts are being received.
EON Function ———————————————————————
With the EON (Enhanced Other Networks) code, the Unit can perform a standby reception which will
enable you to obtain desired information which is available from other stations.
o "EON" will be displayed while receiving stations with an EON code.
o EON Standby reception is applicable for preset stations only.
o You can set EON Standby reception regardless of types of receiving bands.
Setting EON Standby reception
1. Press the EON ON/OFF button.
[TA NEWS INFO], or the last EON information type selected, is displayed.
2. Select information you want by pressing the TA/NEWS/INFO button.
TA:
Identifies that a traffic announcement is being broadcast in your area.
NEWS: News
INFO: Programmes on medical service, weather forecast, etc.
• With each pressing of the TA/NEWS/INFO button, indications will change as follows:
[ TA NEWS INFO ] = [ TA NEWS INFO ] = [ TA NEWS INFO ] =
[ TA NEWS INFO ] = [ TA NEWS INFO ] = [ TA NEWS INFO ] =
[ TA NEWS INFO ] = (back to the beginning)
As soon as your selection is entered the Unit will go into EON Standby reception mode.
If you want to cancel the EON function, turn off the [TA NEWS INFO] indicator by pressing the EON
ON/OFF button.
When this Unit carries out EON Standby reception, the indication will
change as follows:
1. Waiting for EON Standby reception
4 1 or ¡ ¢
PTY SELECT +
4 1 button
PTY SELECT + button =
button again.
[ TA NEWS INFO ]
AUTO
TUNED STEREO
1 2 3 4
5 6 7 8
9 10 11 12
13 14 15 16
CH
MHz
TAPE