JVC CA-TD77R Instructions Manual page 17

4. Adjust the level of the low (LOW), middle (MID), or high (HIGH)
tones.
Using the Unit
1. Select the "LOW", "MID", or "HIGH" tone ranges by adjusting the cursor
keys left and right (4
The display changes with each press of the cursor keys as shown below.
+ Press the left (4 ) cursor key
Ô LOW Ô MID Ô HIGH Ô
Press the right (
2. Adjust the level of the selected tone range by adjusting the cursor keys
up and down ( ¡
Pressing the ¡
key decreases it in 2dB units.
•
Using the Remote Control
1. Press the SEA CONTROL button.
2. Select the "LOW", "MID", or "HIGH" tone ranges by pressing the
The display changes with each press of the buttons as shown below.
+ Press the
Ô LOW Ô MID Ô HIGH Ô
Press the ¡ ¢
3. Adjust the level of the selected tone range by pressing the
button.
You can adjust the level between –6 dB and +6 dB in seven steps.
SET
5. Press the SET button.
"MANUAL 1" blinks on the display.
6. Select the number for the MANUAL setting.
Using the Unit
Press the cursor key to the right or left ( 4
Using the Remote Control
Select the number by pressing the
The display changes with each press of the buttons or cursor keys as shown below.
On the unit:
Ô MANUAL 1Ô MANUAL 2 ÔMANUAL 3 Ô
On the Remote Control:
Ô MANUAL 1Ô MANUAL 2 ÔMANUAL 3 Ô
ENTER
7. Press the ENTER button.
"MEMORY" and the selected memory number are
displayed on the screen, and the adjusted settings are
stored in memory. After a few seconds, the display reverts
to the item that was displayed before you pressed
the MENU button.
• The memory setting will appear in the S.E.A. effect mode
using the manual number.
If you store new settings to a MANUAL number that has already been used, the new settings replace
the existing setting.
¢) cursor key =
or
cursor key increases the level in 2dB units, and pressing the
You can adjust the level between –6 dB and +6 dB in seven steps.
4 1 or ¡ ¢
button.
4 1 button
button=
4 1 or ¡ ¢
+ Press the left ( 4 ) button
Press the right (
+ Press the 4 1 button
Press the ¡ ¢
¢).
or
1 ).
SEA
¢ ) and select the number.
or
button.
¢ ) button=
button=
SEA
1 cursor
3 or 7
SEA
CONTROL
SEA
CONTROL
13