The Walking Belt Is Not Centered Between The Foot Rails; The Walking Belt Slips When Walked On; The Digital Tv Is Not Receiving A Signal; Digital Tv Reception Is Poor - NordicTrack Elite 4000 User Manual

Table of Contents

Advertisement

SYMPTOM: The walking belt is not centered
between the foot rails
IMPORTANT: If the walking belt rubs against the
foot rails, the walking belt may become damaged.
a. First, remove the key and UNPLUG THE POWER
CORD. If the walking belt has shifted to the left,
use the hex key to turn the left idler roller screw
clockwise 1/2 of a turn; if the walking belt has
shifted to the right, turn the left idler roller screw
counterclockwise 1/2 of a turn. Be careful not to
overtighten the walking belt. Then, plug in the
power cord, insert the key, and run the treadmill
for a few minutes. Repeat until the walking belt is
centered.
a
SYMPTOM: The walking belt slips when walked on
a. First, remove the key and UNPLUG THE POWER
CORD. Using the hex key, turn both idler roller
screws clockwise, 1/4 of a turn. When the walk-
ing belt is correctly tightened, you should be able
to lift each edge of the walking belt 2 to 3 in. (5 to
7 cm) off the walking platform. Be careful to keep
the walking belt centered. Then, plug in the power
cord, insert the key, and carefully walk on the tread-
mill for a few minutes. Repeat until the walking belt
is properly tightened.
a
Foot
Rails
SYMPTOM: The digital TV is not receiving a signal
a. Make sure that the correct input source is selected.
See step 2 on page 34 to select an input source.
b. Make sure that the antenna cable or CATV cable is
connected securely to the treadmill. See page 18 to
connect a CATV cable to your fitness equipment.
c. Scan for broadcast or cable signals. See step 4 on
page 37 to scan for signals.
SYMPTOM: Digital TV reception is poor
a. Make sure that the digital TV settings are set cor-
rectly. See HOW TO ADJUST THE TV SETTINGS
on page 36.
b. For the digital TV to operate properly, good recep-
tion is necessary. If you are using an antenna,
make sure that it is properly connected and
adjusted for optimal reception. See HOW TO
CONNECT AN ANTENNA on page 18.
c. Check for the problems listed below and follow the
applicable instructions:
• Ignition (black spots or horizontal streaks that
appear or a picture that flutters or drifts)—
Usually this is caused by interference from
automobile ignition systems, neon lamps, electric
drifts, or other electric appliances. Try changing
the position of your fitness equipment or other
electric appliances to correct the problem.
42

Advertisement

Table of Contents
loading

This manual is also suitable for:

Netl30914.0

Table of Contents