The Walking Belt Is Off-Center Or Slips When Walked On; The Treadmill Will Not Connect To The Wireless Network; The Buttons On The Screen Do Not Work Correctly - NordicTrack ELITE 9500 PRO User Manual

PROBLEM: The walking belt is off-center or slips when walked on
SOLUTION: a. If the walking belt is off-center,
first remove the
key and UNPLUG THE POWER CORD. If the
walking belt has shifted to the left, use the hex
key to turn the left idler roller bolt clockwise 1/2 of
a turn; if the walking belt has shifted to the
right, turn the left idler roller bolt counterclockwise
1/2 of a turn, Be careful not to overtighten the
walking belt. Then, plug in the power cord, insert
the key, and run the treadmill for a few minutes.
Repeat until the walking belt is centered.
b.
if the walking belt slips when walked on, first re-
move the key and UNPLUG THE POWER CORD.
Using the hex key, turn both idler roller bolts clock-
wise, 1/4 of a turn, When the walking belt is cor-
rectly tightened, you should be able to lift each
edge of the walking belt 2 to 3 in, (5 to 7 cm) off
the walking platform. Be careful to keep the walk-
ing belt centered, Then, plug in the power cord, in-
sert the key, and carefully walk on the treadmill for
a few minutes, Repeat until the walking belt is
properly tightened.
PROBLEM: The treadmill will not connect to the wireless network
SOLUTION: a. Perform a network test (see step 9 on page 27).
b. Make sure the wireless settings on your console are correct (see step 2 on page 24).
c. Make sure the settings for your wireless network are correct.
d. If you still have questions, see the front cover of this manual.
PROBLEM: The buttons on the screen do not work correctly
SOLUTION: a. If the screen is not properly calibrated, it will be difficult to touch the correct buttons on the screen.
To calibrate the screen, see step 7 on page 27.
32