One Top Burner, Not Burning Properly; Top Burner Valve DifCult To Turn; Igniters Do Not Spark When The Burner Knob Is Turned To The Lite Position; Igniters Spark But Burner Does Not Ignite - Electrolux E30GF74GPS Technical & Service Manual

faILUrE
One top burner, not burning
properly.
Top burner valve difficult to
turn.
Igniters do not spark when
the burner knob is turned to
the lite position.
Igniters spark but burner does
not ignite.
Igniters continue to spark
after burner is ignited.
Note: Always check the wiring between the components
ChECK
1. Is the burner base and head
installed correctly?
2. Is the orifice, flexible tube or
top burner valve restricted?
1. Can the valve stem be
depressed far enough to
unlock the valve.
1. Does a snapping sound occur
when the valve is turn to the
lite position?
2. Measure the input voltage to
one of the top burner
switches. Is the reading line to
neutral?
3. With the valve set to the lite
position measure the output
voltage of the valve switch. Is
the reading line a neutral?
1. Is the burner heads
installed correctly?
2. Lite the burner with a match.
Is the flame adjusted
properly?
1. Is the flame adjusted
properly?
61
COrrECTION
Yes, go to step (2).
No, install burner base and head cor-
rectly.
Yes, remove the restriction or replace the
part.
No, clean the burner ports
Yes, replace the valve.
No, check the distance between the console
and the manifold pipe.
Yes, wires between module and igniters
shorted the chassis.
No, go to step (2).
Yes, go to step (3).
No, open wire between range terminal
block, and switch.
Yes, replace the spark module.
No, replace the valve switch
Yes, go to step (2).
No, install heads correctly.
Yes, remove and clean the heads.
No, check for a restriction.
Yes, remove and clean the heads. Check
ground wire to module. Replace module.
No, check for a restriction.