Table of Contents
Advertisement
¤
Voltage selector (not applicable for
Australian models)
Use a screwdriver to rotate the
voltage selector so that the voltage
mark is pointing to the same voltage
as where you are plugging in the unit.
(See also the back cover page.)
Voltage mark
#
Power cord
Plug the AC power cord to a wall outlet.
DO NOT plug in before setting the voltage
selector and all connection procedures are
completed.
Connecting a USB Mass Storage Class Device
You can connect a USB mass storage class device such as a
USB flash memory, hard disk drive, multimedia card reader,
digital camera, etc. to this System.
USB cable
(not supplied)
Main unit
• You cannot connect a computer to the
terminal of the System.
Preparing the Remote Control
R6(SUM-3)/AA(15F)
If the range or effectiveness of the remote control decreases,
replace both batteries.
Caution
Do not expose batteries to heat or flame.
(USB memory)
When using the remote
control, point the top of the
remote control toward the
remote sensor as directly as
possible. If you operate it
from a diagonal position,
the operating range (approx.
5 m) may be shorter.
Canceling the Demonstration
2
sec.
DEMO OFF
DEMO START
To start the demonstration, select DEMO START.
Changing the Color System and
Scanning Mode
You can select the video output to match it to the color
system of your TV (NTSC or PAL).
• If you connect a progressive TV through the
COMPONENT jacks, you can enjoy a high quality picture
by selecting progressive scanning mode.
• You can change the setting only while playback is stopped.
1
Enter the color system setting mode.
2
sec.
SCAN MODE
VFP
2
Select the color system and scanning mode.
NTSC / PAL
NTSC or PAL Interlaced scanning.
For a conventional PAL or NTSC TV.
NTSC PROG/
NTSC or PAL Progressive scanning.
PAL PROG
For a progressive NTSC or PAL TV.
3
Store the setting.
ENTER
/SET
Main Unit
ONLY
Remote
INFO
ONLY
PAL
PAL PROG
NTSC PROG
NTSC
6
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
