JVC CA-DXU10 Instructions Manual page 8

@
Speakers
To connect the speaker cords
1Push 2Insert
• When connecting the speaker cords, match their polarity
with that of the speaker terminals: blue/red/green/white to
(+) and black to (–).
For CA-DXU10
From front right speaker (black/blue)
From front left speaker (black/blue)
From center speaker (black/green)
From left
From right subwoofer
subwoofer
(black/red)
(black/red)
For CA-DXU8
From front right speaker (black/blue)
From front left speaker (black/blue)
From center speaker (black/green)
From subwoofer
(black/red)
• Use only speakers with the same speaker impedance as
indicated by the speaker terminals on the rear of the System.
5
3Release
From surround right
speaker (black/white)
From surround
left speaker
(black/white)
From surround right
speaker (black/white)
From surround
left speaker
(black/white)
• The front and center speakers and subwoofer(s) are
magnetically shielded to avoid color distortions on TVs.
However, if not installed properly, it may cause color
distortions. So, pay attention to the following when
installing the speakers.
– When placing the speakers near a TV set, turn off the
TV's main power switch or unplug it before installing the
speakers.
Then wait at least 30 minutes before turning on the TV's
main power switch again.
Some TVs may still be affected even though you have
followed the above instruction. If this happens, move the
speakers away from the TV.
• DO NOT connect more than one speaker to
each terminal.
• DO NOT push or pull the speakers as this
will damage the foot spacers at the bottom
of the speakers.
Speaker layout
To enjoy multi-channel sound, locate the speakers as
follows. If you cannot locate like this, adjust the speaker
setting by using the SPK. SETTING menu (see page 39).
For CA-DXU10
Front left
Center speaker
speaker
Subwoofer
Surround left speaker
For CA-DXU8
Front left
Center speaker
speaker
Surround left speaker
Front right
speaker
Subwoofer
Surround right speaker
Front right
speaker
Subwoofer
Surround right speaker