Connecting A Usb Mass Storage Class Device; Preparing The Remote Control; Cancelling The Demonstration; Changing The Color System And Scanning Mode - JVC CA-DXJ20 Instructions Manual

Connecting a USB Mass storage class device

You can connect a USB mass storage class device such as a
USB flash memory, hard disk drive, multimedia card reader,
digital camera, etc. to this System.
USB cable
(not supplied)
Main unit
• You cannot connect a personal computer to the
MEMORY) terminal of the System.

Preparing the Remote Control

R6(SUM-3)/AA(15F)
When using the remote control, point the top of the
remote control toward the remote sensor as directly as
possible. If you operate it from a diagonal position, the
operating range (approx. 5 m) may be shorter.
• If the range of effectiveness of the remote control decreases,
replace both batteries.
Caution:
Do not expose batteries to heat or flame.

Cancelling the Demonstration

2
sec.
To start the demonstration, select DEMO START.
Changing the Color System and
(USB
Scanning Mode
You can select the video output to match it to the color
system of your TV (NTSC or PAL).
• (CA-DXJ30 only) If you connect a progressive TV through
the COMPONENT jacks, you can enjoy a high quality
picture by selecting progressive scanning mode.
• You can change the setting only while playback is stopped.
1
Enter the color system setting mode.
For CA-DXJ10/J20
2
sec.
2
Select the color system and scanning mode.
NTSC / PAL
NTSC PROG/
PAL PROG
(CA-DXJ30 only)
3
Store the setting.
Main Unit
ONLY
DEMO OFF
DEMO START
Remote
ONLY
For CA-DXJ30
2
sec.
SCAN MODE
PAL PAL PROG
(CA-DXJ30 only)
NTSC PROG NTSC
(CA-DXJ30 only)
NTSC or PAL Interlaced
scanning. For a conventional
NTSC or PAL TV.
NTSC or PAL Progressive
scanning. For a progressive NTSC
or PAL TV.
INFO
6