JVC CA-DXU10 Instructions Manual page 59

~
TV/monitor
Composite video
cord (supplied)
S-Video cord
(not supplied)
Green
Component video cord (not supplied)
• To select progressive scanning mode (see page 6), use
COMPONENT jacks.
• Connect the VIDEO jack, S-VIDEO jack, or
COMPONENT jacks; whichever you want to use.
• You can get better picture quality in the order of—
Composite video ] S-video ] Component video.
Ÿ
Digital audio component
Optical digital cord
(not supplied)
• Set "DIGITAL AUDIO OUTPUT" in the "AUDIO" menu
correctly according to the connected digital audio
equipment (see page 39).
• The digital signal through the OPTICAL DIGITAL
OUTPUT terminal is transmitted only when the "DVD/CD"
is selected as the source.
!
Auxiliary equipment
Red
Stereo audio cord
(not supplied)
Red
Blue
O P T
I C A L
D I G I
T A L
O U T
P U T
Protective cap
White
⁄
AM/FM antenna
To assemble the AM loop antenna
To connect AM/FM antenna
• If the antenna cord is covered with vinyl on the tip, twist and
pull the vinyl off to remove.
AM loop antenna (supplied)
Turn until the best reception is
obtained.
FM antenna (supplied)
Extend it so that you can obtain the best
reception.
For better FM reception
FM outdoor antenna
(not supplied)
• Disconnect the supplied FM antenna, and connect an
outdoor FM antenna using a 75
connector (IEC or DIN45325).
• Make sure the antenna conductors do not touch any other
terminals, connecting cords or the power cord. Also, keep
the antennas away from metallic parts of the System,
connecting cords, and the AC power cord. This could cause
poor reception.
Ω
wire with coaxial type
4