Lower Media Exit Roll Assembly Removal - Lexmark X850e Service Manual

Lower media exit roll assembly removal

1. Remove the finisher front door assembly. See
2. Remove the rear upper cover. See
3. Remove the upper media bin assembly. See
4. Remove upper media bin vertical cover. See
5. Remove the rear lower cover. See
6. Remove the stapler unit frame. See
7. Remove the upper media bin assembly. See
8. Remove the upper media bin vertical cover. See
9. Remove the stapler unit frame. See
10. Remove the media eject clamp motor assembly. See
page 4-66.
11. Remove the media eject unit assembly. See
12. Remove the media compiler unit assembly. See
13. Remove the media eject clutch. See
14. Remove the media eject motor assembly. See
15. Remove the media eject shaft assembly. See
16. Remove the main paddle shaft assembly. See
17. Loosen the two screws securing the belt tensioner bracket (A) to the finisher, and move the bracket down in
the direction of the arrow.
18. Remove the belt (exit) (B) from the lower exit roll drive pulley 20T (C).
"Rear upper cover removal" on page
"Rear lower cover removal" on page
"Stapler unit frame removal" on page
"Stapler unit frame removal" on page
"Media eject clutch assembly removal" on page
A
A
Tighten
second
Tighten
first
"Finisher front door assembly removal" on page
"Upper media bin assembly removal" on page
"Right eject cover removal" on page
"Upper media bin assembly removal" on page
"Right eject cover removal" on page
"Media eject clamp motor assembly removal" on
"Media eject unit assembly removal" on page
"Media compiler unit assembly removal" on page
"Media eject motor assembly removal" on page
"Media eject shaft assembly removal" on page
"Paddle and roll exit assembly removal" on page
B
C
7500-XXX
4-27.
4-24.
4-20.
4-21.
4-23.
4-54.
4-20.
4-21.
4-54.
4-59.
4-69.
4-77.
4-78.
4-74.
4-85.
Rear
Repair information
4-81