Punch Waste Box Full - Lexmark X850e Service Manual

Step Check
4 Perform a print test.
Does the error still occur?
5 Perform a print test.
Does the error still occur?

Punch waste box full

Step Check
1 Check the sensor (punch waste box full) for correct
installation.
Is the sensor installed properly?
2 Check the sensor (punch waste box full).
1. Enter the Diagnostics Menu.
2. Touch FINISHER TESTS.
3. Touch Sensor Test.
4. Touch Punch and Staple.
5. Touch Punch waste box full.
Open the finisher front door.
Remove the punch waste box.
Insert a sheet of white media into the sensing area of
the sensor (punch waste box full).
Does the operator panel display change every time the
sensing area of the sensor (punch waste box full) is
blocked?
3 Perform a print test.
Does the error still occur?
Yes No
Replace the Problem solved.
bridge unit
interface card
assembly.
Go to "Bridge
unit interface
card assembly
removal" on
page 4-115.
Go to step 5.
Replace the Problem solved.
finisher controller
card assembly.
Go to "Finisher
controller card
assembly
removal" on
page 4-116.
Yes No
Go to step 2. Reinstall the
sensor (punch
waste box full).
Go to
(punch waste
box full)
removal" on
page
Go to step 4. Go to step 3.
Replace the Replace the
sensor (punch connection.
waste box full).
"Sensor
Go to
(punch waste
box full)
removal" on
page 4-53.
Diagnostic information
7500-XXX
"Sensor
4-53.
2-95