Table of Contents
Advertisement
Leica mojo3D, Running the mojo3D for the First Time
Master input
source setup,
step-by-step
3. Tap
to continue.
1. On the master input source screen, in the list at the left of the screen, tap to
select the master input source.
2. In the list at the right of the screen, tap to select the input mode.
The Master Input Source & Input Mode options available will depend on the
configuration of the individual system:
•
mojo3D / Touch: the on screen coverage mapping is activated by
touching the Master Record button on the screen.
•
mojo3D / Master Input: the on screen coverage mapping is activated
by sensing a voltage connected to the Master wire on the mojo3D
power cable.
•
Leica AS400 / Single: the on screen coverage mapping is activated by
sensing a voltage connected to the Master wire on the Leica AS400
controller port. This is only available with specific rate controller cables.
•
Leica AS400 / Dipole Switch: the on screen coverage mapping is acti-
vated by sensing a pair of switching wires. This is only available with
specific rate controller cables.
3. Tap
to continue.
40
Advertisement
Table of Contents
