Leica mojo3D User Manual page 221

Leica mojo3D, mojo3D Enhancements
5. Use the on-screen number pad to enter the vehicle height meas-
urement. Tap
6. Tap to continue.
7. Drive to a flat, level area and stop. Tap the square grey button beside the
instruction when the vehicle is stationary.
8. Wait until the tuning of inertial sensors is complete, as shown by the progress
bar, and then turn the vehicle around through 180°, and stop in exactly the same
position as before.
9. Tap the square grey button beside the instruction.
10. Wait until the further tuning of the inertial sensors is complete, as shown by the
progress bar, and then tap
Both the indicators CAN Bus Connected and Steering Kit Active should have a
green tick mark displayed.
If this is not the case, carry out the following checks:
• Check that the Electric Steer Kit switch is ON.
• Check all cable connections.
• Check all switch connections.
When both of the indicators have a green tick mark beside them, tap
continue.
on the number pad when finished.
to continue.
to
221