Connections - Yamaha HTR-5750 Owner's Manual

O POWER switch
Normally, set this switch to the ON position to use the
subwoofer. In this state, you can turn on the subwoofer
or turn the subwoofer into the standby mode by
pressing the STANDBY/ON (0) button. Set this switch
to the OFF position to completely cut off the
subwooter's power supply from the AC line.
• INPUT
terminals
Used to input line level signals from the amplifier.
(Refer to
"CONNECTIONS"
for details.)
0 AUTO STANDBY (HIGH/LOW/OFF) switch
This switch is originally set to the OFF position. By
setting this switch to the HIGH or LOW position, the
subwoofer's automatic power-switching function
operates as described below. If you do not need this
function, leave this switch in the OFF position.
" Make sure to change the setting of this switch only
when the subwooter is set in the standby mode by
pressing the STANDBY/ON (0) button.
O
PHASE switch
Normally this switch is to be set to the REV (reverse)
position. However, according to the listening condition
or your preference, there may be a case when better
sound quality is obtained by setting this switch to the
NORM
(normal) position. Select the better position by
monitoring the sound.
Ili the source being played is stopped and the input signal is
cut off for 7 to 8 minutes, the subwoofer automatically
switches to the standby mode.
(When the
subwoofer
switches to the standby mode by the automatic power-
switching function,
the power indicator lights up in red.)
When you play a source again, the power of the subwooler
turns on automatically by sensing audio signals input to the
subwooter.
This function operates by sensing a certain level of
low
frequency input signal. Usually set the AUTO STANDBY
switch to
the
LOW position. However, if this function does
not operate smoothly. set the switch to the
HIGH position.
In
the HIGH position, the power will turn on even with a low
level of input signal. But please be aware that the subwoofer
may not switch to the standby mode when there is an
extremely low input signal.
The power might turn on unexpectedly by sensing noise
from other appliances. If that occurs, set the AUTO
STANDBY switch to the OFF position and use the
STANDBY/ON button to switch the power between on
and in the standby mode manually.
This function detects the low-frequency components
below 200 Hz of the input signals (i.e., the explosion in
the action movie, the sound of the bass guitar or the bass
drum.
etc.).
The minutes required to switch the subwoofer to the
standby mode might change by sensing noise from other
appliances.
This function is available only when the power of the
subwoofer is on (by pressing
the STANDBY/ON button),
E-6