Yamaha HTR-5750 Owner's Manual page 24

• IMPEDANCE SELECTOR switch
Do not change the setting of the IMPEDANCE
SELECTOR switch when the unit power is switched on,
as doing so may damage the unit.
if this unit fails to turn on when STANDBY/ON is pressed
on either the front panel or remote control. the
IMPEDANCE SELECTOR switch
may not he fully slid to
either position. If this is the case, slide the switch all the
way to either position when this unit is in standby mode.
Select the switch position (left or right) according to the
impedance of the speakers in your system.
Switch position
Speaker
Front
Left
Center. Surround. Surround hack
Front
Right
Center. Surround. Surround hack
1
12-
IMPEDANCE SELECTOR
switch
Impedance level
If you use one set (A or B I( the impedance of each speaker must be
4 S2 or higher.
If you use two
SOT I A and B). the impedance of each speaker must be
8 SI or higher.
The impedance of each speaker must be t, 12 or higher.
If you tse one (,er (A or B1. the impedance of each speaker
II1USL
he
g S2 or higher.
If you (r,e two sets (A and B). the impedance of each speaker must he
16 52 or higher.'
The impedance of each speaker tart on he 8 ca or higher.
The Canada model cannot use two separate speaker
systems (A arid
Bi simultaneously
whcn the switch is set to the right position.
20