Connections - Yamaha RX-V395 Owner's Manual

CONNECTIONS WITH OTHER COMPONENTS
Never plug in this unit and other components until all connections are completed.
When making connections between this unit and other components, be sure all connections are made correctly; that is to say L (left)
to L, R (right) to R, "+" to "+" and "–" to "–". Also, refer to the owner's manual for each component to be connected to this unit.
* If you have YAMAHA components numbered as 1, 3, 4, etc. on the rear panel, connections can be made easily by connecting
the output (or input) terminals of each component to the same-numbered terminals on this unit.
Turntable
*1
MAIN
75ΩUNBAL.
L
R
FM
ANT
GND
GND
AM
ANT
PHONO
50kHz
/ 9kHz
100kHz
/10kHz
FM / AM
FREQUENCY
STEP
CD player
*1 Ground (GND) terminal (For turntable use)
Connecting the ground wire of the turntable to the GND
terminal will normally minimize hum, but in some cases
better results may be obtained with the ground wire
disconnected.
*2 Voltage Selector <China and General models only>
The voltage selector on the rear panel of this unit must be
set for your local main voltage BEFORE plugging into the
AC power supply.
Voltages are 110/120/220/240 V AC, 50/60 Hz.
8

CONNECTIONS

Monitor TV
6CH DISCRETE INPUT
CENTER
SURROUND
L
R
SUB
WOOFER
VIDEO SIGNAL
MONITOR DVD/LD TV/DBS VCR
OUT IN
OUT
AUDIO SIGNAL
CD TAPE/MD DVD/LD TV/DBS VCR
IN OUT
IN OUT
(PLAY) (REC)
1 4
3
Tape deck,
MD recorder, etc.
TV/Satellite tuner
<General model>
A
IMPEDANCE SELECTOR
SET BEFORE POWER ON
B
MAIN A OR B: 4ΩMIN. /SPEAKER
A B: 8ΩMIN. /SPEAKER
CENTER : 6ΩMIN. /SPEAKER
REAR : 6ΩMIN. /SPEAKER
REAR
R
(SURROUND)
MAIN A OR B: 8ΩMIN. /SPEAKER
A B:16ΩMIN. /SPEAKER
CENTER : 8ΩMIN. /SPEAKER
REAR : 8ΩMIN. /SPEAKER
LD player,
DVD player, etc.
*3 AC OUTLETS (SWITCHED)
<Europe, Canada, U.S.A., China and General models>
..................................................... 2 SWITCHED OUTLETS
<U.K. and Australia models> .......... 1 SWITCHED OUTLET
Use these to connect the power cords from your
components to this unit.
The power to the SWITCHED AC OUTLETS is controlled
by this unit's STANDBY/ON switch or the provided remote
control transmitter's POWER
supply power to any component whenever this unit is
turned on.
The maximum power (total power consumption of
components) that can be connected to the SWITCHED AC
OUTLETS is 100 watts.
Video cassette recorder
VOLTAGE SELECTOR
*3
AC OUTLETS
I00W MAX. TOTAL
SWITCHED
/I key. These outlets will
*2
To AC outlet