Troubleshooting Guide
Error
Error Type
No.
DC voltage charging for
23
inverter compressor driving
defect
Error diagnosis and countermeasure flow chart
Is noise filter and
fuse normal?
[refer electric
component part]
Yes
Is capacitor normal?
[refer electric
component part]
Yes
Is the voltage of 3 phase
diode more than maximum
270V?*
Yes
Check whether all the
connections and terminals
is normal and reconnect
Copyright ©2009 LG Electronics. Inc. All right reserved.
Only for training and service purposes
Error Point
Problem in DC charging volt-
age after starting relay
turned on
No
Replace Noise Filter or Fuse
No
Replace Capacitor
No
Replace outdoor unit inverter PCB
* After indoor unit turned on and the compressor is not operated,
just before magnetic switch is turned on
the voltage between the 2 terminal as below is more than 270V
- 256 -
Main Reasons
1. Looseness of DC link terminal
2. Damage in starting relay
3. Capacitor damage
4. Defective sensing circuit of the inverter PCB
LGE Internal Use Only