Raymarine A Series Installation And Operation Instructions Manual page 86

4. Ensure the bezel is correctly aligned with the
display, as shown.
5. Apply firm but even pressure to the bezel along
the:
i. Outer edges - work from the sides upwards
and then along the top edge, to ensure that it
clips securely into position.
ii. Inner edges - particularly along the chart card
door edge, to ensure that the bezel sits flat.
6. Check that all control buttons are free to operate.
Removing the front bezel
Before proceeding ensure the memory card slot door
is open.
2
1
1
Important: Use care when removing the bezel.
Do not use any tools to lever the bezel; doing so
may cause damage.
1. Place both your thumbs on the upper left edge
of the display, at the positions indicated in the
diagram above.
86
2. Place your fingers underneath the bezel, at the
positions indicated in the diagram above.
3. In a single firm motion, apply pressure to the
outer edge of the display with your thumbs and
pull the bezel towards you using your fingers.
The bezel should now come away from the display
easily.
D12274-1
D12275-1
a Series / c Series / e Series