Raymarine A Series Installation And Operation Instructions Manual page 182

Menu item Description
Fish If the Fish alarm is enabled, an alarm tone is triggered
if a target is detected that meets the Fish alarm
sensitivity.
The following options are available under Fish Alarm.
• Enable — Enables and disables Fish Alarms.
• Fish alarm sensitivity — If the Fish alarm is set
• Fish alarm depth limits — Enables and disables
• Fish alarm shallow limit — Specifies the lower
• Fish alarm deep limit — Specifies the upper value
Switch Panel Alarms
Menu item Description
Switch Panel Alarms The Switch Panel Alarms section is only displayed
when connected to a correctly configured Raymarine
Digital Switching system.
Engine Alarms
Menu item Description
Show alarms for When enabled, warning alarms from connected,
engine errors compatible engine management systems will be
displayed on the MFD.
The engine alarms listed below can be enabled or
Check engine
disabled using the Alarm Manager
• Over temperature
• Low oil pressure
• Low oil level
• Low fuel pressure
• Low system voltage
• Low coolant level
• Water flow
• Water in fuel
182
to On, an alarm is triggered when the fish return
strength reaches the sensitivity that you specify.
the shallow and deep fish alarm limits.
value for the Fish alarm depth limits.
for the Fish alarm depth limits.
Options
• –9.98°F to Upper Temp Limit
Enable:
• Enabled (Ticked)
• Disabled (Un-ticked) (default)
Fish alarm sensitivity
• Default: 5
• Range: 1 to 10
Fish alarm depth limits:
• Enabled (Ticked)
• Disabled (Un-ticked) (default)
Fish alarm shallow limit
Default values:
• 0.6 m / 2 ft / 0.3 fa (default)
Range:
• 0.6 m to Fish alarm deep limit
• 2 ft to Fish alarm deep limit
• 0.3 fa to Fish alarm deep limit
Fish alarm deep limit
Default values:
• 305 m / 1,000 ft / 167 fa
Range:
• Fish alarm shallow limit to 914 m
• Fish alarm shallow limit to 3,000 ft
• Fish alarm shallow limit to 500 fa
Options
• Enabled (Ticked) (default)
• Disabled (Un-ticked)
Options
• Enabled (Ticked) (default)
• Disabled (Un-ticked)
• Enabled (Ticked) (default)
• Disabled (Un-ticked)
a Series / c Series / e Series