Mitsubishi Electric FR-F720P-0.75K to 110K Instruction Manual page 234

(6) Switching of command source by external terminal (X67)
⋅ In Network operation mode, the command source switching signal (X67) can be used to switch the start command
source and speed command source. This signal can be utilized to control the signal input from both the control
terminal and communication.
⋅ Set "67" in any of Pr. 178 to Pr. 189 (input terminal function selection) to assign the X67 signal to the control terminal.
⋅ When the X67 signal is OFF, the start command source and speed command source are control terminal.
X67 Signal State
No signal assignment
ON
OFF
REMARKS
⋅ The ON/OFF state of the X67 signal is reflected only during a stop. It is reflected after a stop when the terminal is switched while
the inverter is running.
⋅ When the X67 signal is OFF, a reset via communication is disabled.
CAUTION
⋅ Changing the terminal assignment using Pr. 178 to Pr. 189 (input terminal function selection) may affect the other functions. Set
parameters after confirming the function of each terminal.
♦ Parameters referred to ♦
Pr. 28 Multi-speed input compensation selection
Pr. 59 Remote function selection
Pr. 79 Operation mode selection
Start Command Source
According to Pr. 338
Command is valid only from control terminal signal.
Refer to page 106.
Refer to page 106.
Refer to page 206.
Selection of operation mode and
Speed Command Source
According to Pr. 339
operation location
223
4