Table of Contents
Advertisement
1-5-2. Notes on Installation
c
To avoid an injury, do not install the unit on rickety table.
Ventilation and Installation Space for Servicing
. Do not block an exhaust section and an air vent (rear panel).
. In order to make a unit with good ventilation, ensure sufficient clearance around the unit. Especially,
keep more than 10 cm behind the unit.
. In order to ensure a workspace, more than 20 cm behind the unit is required. Be sure to keep drawing
space.
n
In consideration of service operation, it is recommended that keep more than 20 cm of headroom.
When Stacking the Units
. The maximum three DNW-A28/A28P can be stacked up, provided that these are installed on the
horizontal surface such as a stable desktop.
. When stacking the units, fit the feet of the upper unit onto the dents of the lower unit.
n
Do not stack the unit other than the DNW-A28/A28P.
The unit may cause malfunction if there is discrepancy in positions of the foot and dent regardless of
its weight.
Battery Adapter Attachment
When the unit is operated with a battery, be sure to use the following battery adapter and battery pack:
. Battery adapter:
BKP-L551
. Battery pack:
BP-L60(A)/L90(A)
Attaching Position of the Battery Adapter
Remove the two screws from the left side of the unit and install the battery adapter.
Regarding installation, refer to the operation manual.
DNW-A28
DNW-A28P
Screws
DNW-A28/A28P Left side view
1-5. Installation Space
1-5
Advertisement
Table of Contents
