Required Adjustment Tools - Epson Stylus Photo R1800 Service Manual

EPSON Stylus Photo R1800/R2400

5.1.3 Required Adjustment Tools

The following table lists the adjustment tools required for adjustment of this
product.
Table 5-5. List of Tools
No. Name Part Code
Adjustment
1
Program
–
G-26
2 1080614
G-45
3 1033657
G-71
4 1304682
PG Adjustment
5 1276333
Gauge
PF Tension
6 1231678
Measuring Tool
Adjustment
Category Overview
This adjustment program is
Software
designed to display the
required adjustment items in
the appropriate order when a
replacement part is selected,
and provides workers with
the accurate adjustment
order.
For the Parallelism Adjust
Grease
Bushing, Lower Paper
Guide, Driven Release Shaft,
etc.
For the PF Roller, Front
Grease
Paper Guide, Rear Paper
Guide and etc.
For the Carriage Unit and
Grease
Carriage Shaft.
A gauge exclusively used to
Gauge
make PG Adjustment. Check
the corrction value by
energizing it in the same way
as for Stylus Photo R800.
Used to check whether or not
Measuring
the tension of the PF Drive
tool
Belt is within the specified
value. If load is greater than
the specified value, the PF
Motor may generate heat,
burning off the coil.
Reversely, if load is less than
the specified value, the paper
feed position may shift.
Adjustment Items and Overview
Table 5-5. List of Tools
No. Name Part Code
PF Roller Shaft
7 1304993
Position
Adjustment Jig
Level
8 1304994
Note : For tools required for the Colorimetric Calibration,
147.
Revision B
Category Overview
Used to check whether or not
Adjusting
the deflection amount of the
jig
PF Roller Shaft is within the
specified value. Adjustment
values are confirmed in a
pair with the level block.
Used to check whether or not
Adjusting
deflection amount of the PF
jig
Roller Shaft is within the
specified value. Adjustment
values are confirmed in a
pair with the PF Roller Shaft
Position Adjustment Jig.
See Section 5.2.4 on page
136