Table of Contents
Advertisement
NOTICE
Before each use: With seat cover closed, open
and close the holding tank valve (Figure J9)
to vent any pressure that may have built up
as a result of heat or altitude. This prevents
upward splashing of bowl contents when toilet
is flushed.
Figure J9: Porta-Potti - Bellows Flush Operation
Bellows Flush Operation:
1. Pull out holding tank valve handle (Figure J9).
2. Push down on bellows to rinse the bowl.
3. Push valve handle all the way in to insure an odor-
tight seal.
Emptying of Portable Models:
1. Empty when waste holding tank level appears full.
DO NOT ALLOW THE TANK TO BECOME OVER-
FILLED.
2. Make sure waste valve handle is in the closed
position.
3. Remove fresh water tank from waste holding tank
(Figure J10).
Figure J10: Removing Fresh Water Tank
4. Remove waste holding tank from hold down
brackets.
5. Carry the waste holding tank to any permanent toi-
let facility. Rotate the pour-out spout to the desired
position. Remove the cap. Depress the air relief
valve with your thumb while emptying (Figure J11).
Waste & Water Systems - Section J
Figure J11: Emptying Waste Holding Tank
6. Rinse waste holding tank and recharge as
described under preparation portion of this section.
7. Reassemble unit and fasten to floor or deck.
C. Head Pumpout Option
The waste holding tank should be emptied when
waste holding tank level gauge indicator on the porta-
potti (models with pumpout option only) has changed
from green to red (Figure J12). DO NOT ALLOW
THE TANK TO BECOME OVERFILLED.
Figure J12: Porta-Potti
If equipped with the head pump out, the waste can
be removed from the tank at a pumping station. A
deck plate fitting labeled WASTE, is provided for this
pur pose. See Figure J13. Most mari na fueling facilities
provide servic e for waste pump out. For waste holding
capacities, please refer to the manufacturer's literature
and/or our website.
Figure J13: Pumpout Waste Deck Fitting
Owner's Manual Page 81
Advertisement
Table of Contents
