Installing Client Software For Smb Printing; Installation For Smb Printing Using The Installer - Toshiba e-studio 452 Printing Manual

2 Installing Client Software for Windows

Installing Client Software for SMB Printing

This section describes how to set up the client software for SMB printing which is available for
the local area network over TCP/IP.
There are three ways to set up the printer drivers for SMB printing:
Using the installer in the Client Utilities CD-ROM
When you insert the Client Utilities CD-ROM into your CD-ROM drive, the installer automati-
cally starts. You can install printer drivers and other client software using the installer. If you
want to install printer drivers as well as other client software, this method is convenient.
P.64 "Installation for SMB Printing Using the Installer"
Using Point and Print
You can install the printer driver by double-clicking network queues on the system. By this
method, printer drivers can be downloaded from the system so that the Client Utilities CD-
ROM is not required. However, other client software cannot be installed using this method.
P.71 "Installation for SMB Printing by Point and Print"
Using Add Printer Wizard
When you want to install the printer drivers without connecting to the equipment using Point
and Print, install the printer drivers using the Add Printer Wizard.
P.75 "Installation for SMB Printing by Add Printer Wizard"
Before installing the printer driver for SMB printing, check with your system administrator to
make sure of the following:
- This equipment is connected to the network and turned on.
- The TCP/IP setting is correct on this equipment and your computer.

Installation for SMB Printing Using the Installer

You can install the client software and set up the SMB printing using the installer in the Client
Utilities CD-ROM.
It assumes using SMB printing in a small network. If you can use the Windows NT 4.0, Windows
2000, Windows XP, Windows Server 2003, or Windows Vista as a print server, it is recom-
mended to set up for printing via Windows print server. For further information about setting up
printing via a Windows print server, see the Network Administration Guide.
Installing the client software for SMB printing using the installer
The following describes an installation on Windows XP. The procedure is the same when other
versions of Windows are used.
You must log into Windows as a user who has the "Administrators" or "Power Users" privi-
lege. You must log into Windows as a user who has the "Administrators" privilege when
using Windows XP/Server 2003/Vista.
Only users with the administrator privilege can perform this on Windows Vista.For users
without the administrator privilege, installation on Windows Vista is possible by performing
the following procedure and having the administrator privilege temporarily.
- Select "Open folder to view files" in the AutoPlay menu and click [OK].
- Open the Client folder, click "Setup.exe" and then select "Run as administrator".
- Enter the administrator's password of the client computer to operate with an administra-
tor's privilege and click [OK].
64

Installing Client Software for SMB Printing