Stapling And Hole Punching - Toshiba e-studio 452 Printing Manual

Printing an enlarged or reduced image by specifying the zoom ratio
manually
1
Display the Basic tab and check the "Manual Scale" box. Then
enter the percentage of zoom ratio.
The zoom ratio can be set from 25% to 400% in units of 1%.
2
Set any other print options you require and click [OK].
3
Click [OK] or [Print] to send the print job.
Enlarged or reduced image is printed by specified zoom ratio.

Stapling and Hole Punching

You can staple and punch the paper.
Stapling is not available if a finisher is not installed.
Hole Punching is not available if a hole punch unit is not installed.
Stapling the paper
1
Display the Finishing tab and check the "Staple" check box. Then
select how to staple.
Upper Left — Select this to staple the printed document in the upper left.
Upper Right — Select this to staple the printed document in the upper right.
Center Top — Select this to staple the printed document double along the top edge.
Middle Left — Select this to staple the printed document double along the left side.
Center Double — Select this to fold and staple the printed document double in the
center.
The selectable options vary depending on the paper size.
"Center Double" can be selected only when the Saddle Stitch Finisher is installed and
configured on the Configuration tab.
2
Set any other print options you require and click [OK].
3
Click [OK] or [Print] to send the print job.
The output is stapled for each copy.
Printing with Extended Print Functionality 259