Toshiba e-studio 452 Printing Manual page 313

- Job Separator Lower — Select this to route the output to the lower tray of the Job Sep-
arator.
"Stapling and hole punching cannot be performed according to the type of the Finisher
installed and the destination setting.
When "Auto" is select at the Destination option, the paper might be delivered to a tray
which cannot carry out stapling or hole punching according to the setting of the equip-
ment.
For e-STUDIO452 Series, "Tray 1" and "Tray 2" can be selected when the Hanging Fin-
isher, Finisher (Type A), Finisher (Type B), or Saddle Stitch Finisher are installed.
When the Finisher (Type B) is installed in the e-STUDIO452 Series and stapling is
enabled, select "Tray 2".
For e-STUDIO282 Series, "Tray 1" and "Tray 2" can be selected when the Hanging Fin-
isher is installed, and "Tray 1" can be selected when the Saddle Stitch Finisher is
installed.
When the optional Job Separator is installed, you can select "Job Separator Upper" and
"Job Separator Lower" instead of "Inner Tray".
2) Hole Punch
This sets whether or not a print job is hole punched.
- Off — Select this to print without hole punches.
- Long Edge Punch without rotation — Select this to create holes on the left side for the
portrait document, or on the top for the landscape document.
- Short Edge Punch without rotation — Select this to create holes on the top for the por-
trait document, or on the right for the landscape document.
- Long Edge Punch with 180 degree rotation — Select this to create holes on the right
side for the portrait document, or on the bottom for the landscape document.
Printing from Application on Mac OS 8.6 to 9.x 313