Center Margin; Outer Margin - Toshiba e-studio 452 Printing Manual

Alternate
Option Value
Value
left2right=on ON
If left2right=off then long edge binding is selected, otherwise if left2right=on then short edge
binding is used.
Example: The command to select left to right page layout for booklet printing mode is
"lp -o left2right=on filename".

Center Margin

The booklet mode center margin can be selected using the following options.
Alternate
Option Value
Value
centermargin
=value
Example: The command to select the center margin value for booklet printing mode is
"lp -o centremargin=value filename".

Outer Margin

The booklet mode outer margin can be selected using the following options.
Alternate
Option Value
Value
outermargin
=value
Example: The command to select the outer margin value for booklet printing mode is
"lp -o outermargin=value filename".
Description
Select left to right page layout for booklet printing mode.
This is the default setting.
If the value is ON then the layout of the pages is from
Left to Right as shown in the figure below.
Description
Select the center margin value for booklet printing
mode.
This value specifies in pixels the Center Margin or the
"Gutter". This is in addition to the center margin already
specified by the application. The valid range for value is
0 - 300. Default is 0.
Description
Select the outer margin value for booklet printing mode.
This value specifies in pixels the Outer Margin or the
"Creep" per page, which should take place while print-
ing a booklet. The valid range for value is 0 - . Default is
0.
Printing from an Application 331