Page Layout; Center Margin; Outer Margin - Toshiba e-STUDIO400P Printing Manual

4 PRINTING FROM UNIX/Linux

Page Layout

The booklet mode page layout can be selected using the following options.
Option Value Alternate Value
left2right=off OFF
left2right=on ON
If left2right=off then long edge binding is selected, otherwise if left2right=on then short edge binding is used.
Example: The command to select left to right page layout for the booklet printing mode is "lp -o left2right=on <filename>".

Center Margin

The booklet mode center margin can be selected using the following options.
Option Value Alternate Value
centermargin
=value
Example: The command to select the center margin value for the booklet printing mode is "lp -o centermargin=value
<filename>".

Outer Margin

The booklet mode outer margin can be selected using the following options.
Option Value Alternate Value
outermargin
=value
Example: The command to select the outer margin value for the booklet printing mode is "lp -o outermargin=value
<filename>".
170 Printing From Application
Description
Select right to left page layout for the booklet printing
mode.
This value decides the layout of the pages in the
booklet.
If this value is OFF then the layout of pages is Right to
Left as shown in the figure below.
Select left to right page layout for the booklet printing
mode.
This is the default setting.
If the value is ON then the layout of the pages is from
Left to Right as shown in the figure below.
Description
Select the center margin value for the booklet printing
mode.
This value specifies in pixels the Center Margin or the
"Gutter". This is in addition to the center margin already
specified by the application. The valid range for value is
0 - 300. Default is 0.
Description
Select the outer margin value for the booklet printing
mode.
This value specifies in pixels the Outer Margin or the
"Creep" per page, which should take place while
printing a booklet. The valid range for value is 0 - 600.
Default is 0.