Oven Door Components; Oven Door; Door Adjustments; Door Gasket - Wolf Wall Ovens Technical & Service Manual

OVEN DOOR COMPONENTS:

Oven Door Removal
First, open the door to its fully opened position. Next,
extract the screw and remove the plate from each side
of the door hinges. Now, install the pin (this pin is ini-
tially shipped with the unit and taped to the inside of the
oven door) through the hole in the left hinge arm. 9See
figure 4-36).
If the pin devise is too long, it will rub against the
inner door liner and chip the porcelain.
Lift the oven door to about a 60 degree angle from the
horizontal. Now, pull the door away from the oven while
continuing to lift and remove.
To reinstall oven door(s), grasp the oven door on oppo-
site sides and lift the door until the hinges are aligned
with the openings in the oven frame. Hold the door at
about a 30 degree angle from the vertical. Slide the
hinges into the openings until the bottom hinge arms
drop fully into the hinge receptacles. Lower the door to
the fully opened position and remove the pin from the
left hinge arm. Open and close the door completely to
ensure it is properly installed.

Door Adjustments

To adjust doors for height. Loosen the screws on the
hinge pocket. Now, raise or lower the oven door to the
desired height. Next, retighten the hinge pocket
screws. Do this procedure for each side of the oven
door until the desired height is obtained.
Door Gasket Removal
First, open the oven door. Now, locate the small clips
attached to the underside of the gasket and gently pull
the clips from the oven door liner. Next, pull the ends of
the gasket out from the bottom of the door liner and
remove. (See Figure 3-37).
Outer Door Skin Assembly Removal
First, remove the oven door assembly and lay on front.
Extract the two screws on the inside top of the door
liner. Next, extract the three screws at the bottom of
the outer door skin. Then, remove the outer door skin
with handle and lay on front. Now, extract the four
screws from the door handle assembly and remove.
Remove the heat shield and insulation from the outer
door skin. (See Figure 4-38).
Component Access and Removal
W W a a l l l l O O v v e e n n s s
4-13
Plate
Screw
Hinge pin
Figure 4-36. Hinge Pin Installation.
Figure 4-37. Door Gasket Removal.
Figure 4-38. Outer Door Skin Removal.