Control Panel Components; Control Panel Assembly; Control Panel Drive Motor - Wolf Wall Ovens Technical & Service Manual

CONTROL PANEL COMPONENTS:

TURN OFF THE ELECTRICAL POWER GOING TO
THE OVEN BEFORE SERVICING.
IN ORDER TO REMOVE THE CONTROL PANEL
AND COMPONENTS BEHIND IT, THE OVEN WILL
HAVE TO BE PULLED OUT APPROXIMATELY 12
INCHES FROM ITS INSTALLATION AND THE
FRONT OVEN TOP PANEL WILL NEED TO BE
REMOVED.
Control Panel Assembly Removal
Unplug the control panel flex strip from the oven con-
troller. Extract the screws that secure the right side
control panel mounting plate and remove the plate.
(See Figure 4-1).
Now, slide the control panel assembly with flex strip out
from the c-channels. (See Figure 4-2).
NOTE: Make sure you don't loose the plastic flange
bearings located on each end of the control panel
assembly.
Control Panel Drive Motor Assembly Removal
Unplug the wire harness connector for the drive motor
from the stepper motor control board. Now, extract the
screws that secure the drive motor assembly to the
c-channels. (See Figure 4-3). Now, slide the drive
motor assembly from the unit. (See Figure 4-4).
Component Access and Removal
W W a a l l l l O O v v e e n n s s
4-3
Figure 4-1. Control Panel Removal.
Figure 4-2. Control Panel Removal.
Figure 4-3. Control Panel Drive Motor Removal.
Figure 4-4. Control Panel Drive Motor Removal.