Oven Installation; Trim Installation - Wolf Wall Ovens Technical & Service Manual

Oven Installation

Use the upper edge of the cavity opening and the bot-
tom of the oven chassis side as gripping points to lift
the oven into the cabinet cutout. Slide the oven into the
recessed area until the unit is approximately six inches
from being fully installed. This will allow for installation
of the oven trim kit.
NOTE: The oven door(s) may be removed to reduce
the weight of the oven when lifting into cabinet opening.
Do not lift or carry the oven door(s) by the door
handle.

Trim Installation

Attach the left and right side trim to the bottom and mid-
dle trim prior to installing on the oven.
(See Figure 2-1).
NOTE: The middle trim is for double ovens only.
Peel off the adhesive backing on the flat washers.
Attach the flat washers centered over the holes of the
raised sides of the oven cavity frame.
NOTE: Four washers for single oven and eight wash-
ers for double oven.
Install the trim to the oven using the screws provided in
the trim kit. Now, locate the mounting holes found on
the sides of the oven trim. Then, use a drill with a 1/16"
drill bit and drill four pilot holes for the cabinet mounting
screws. Install the mounting screws through the oven
side trim and into the cabinet. (See figure 2-2).
NOTE: Do not overtighten the mounting screws.
FAILURE TO INSTALL THE MOUNTING SCREWS
MAY RESULT IN MOVEMENT OR TIPPING OF THE
OVEN DURING USE.
Do not block the oven air exhaust located at the
bottom of the oven. Blocking the exhaust may
result in cabinet damage and poor baking perform-
ance.
W W a a l l l l O O v v e e n n s s
2-3
Installation Information
Flat Washers
Figure 2-1. Trim Installation
Figure 2-2. Cabinet Mounting Screws
8-32 2x3/4"
Sc crew
8-18x x1/2"
Scr rew
Mounting Screw
6-18x1"