Lancia Lybra Owner's Handbook Manual page 96

Set the volume according to the
car speed (SCV)
IMPORTANT For road safety rea-
sons, this setting must not be made by
the driver.
Select the SPEED-CONTROLLED
VOLUME (SCVOL) setting (value
from -- to 34) (fig. 89):
– "SCVOL 19": standard setting
– "SCVOL - -": setting off
– "SCVOL 34": top effectiveness
Adjust the setting as follows:
1) With the car at a standstill and
the engine running: set required vol-
ume by means of knob 9 (fig. 76).
fig. 88
2) Press the EXP 14 button for ap-
proximately three seconds until the
message "EXPERT" appears on the
display.
3) Select "SCVOL" settings by
means of either button 17 or 18 .
4) For higher speeds: press either
buttons 4 or 5 to set the required vol-
ume:
– button 5: VOL + (to turn the vol-
ume up)
– button 4: VOL - (to turn the vol-
ume down).
5) Press the EXP 14 button for
longer than two seconds.
fig. 89
Activating the safety code
If the message "CODE" appears on
the display, the code is not on.
If the message "SAFE" appears on
the display, the code is on.
IMPORTANT For more detailed in-
structions, see the following chapter.
SAFETY CODE
The sound system safety code is
written on the CODE card (fig. 90).
The code is not activated by the man-
ufacturer.
If you have activated the sound sys-
tem safety code: the sound system will
be electronically protected if the elec-
trical power is disconnected. It can
only be used again by entering the
code.
fig. 90
LANCIA
95