Lancia Lybra Owner's Handbook Manual page 24

Self-test
and door/bonnet/boot checks
Check that the doors, bonnet and
boot are correctly closed if a second
beep is heard when the alarm is
switched on. Then try to switch the
alarm back on.
The system will cut out the doors,
bonnet and boot from the surveillance
if they are not properly closed.
If the doors, the bonnet and the boot
are properly closed and the second
beep is heard again, it means that the
system self-test function has found a
fault. Contact a Lancia Dealership.
SWITCHING ON THE ALARM
AND CUTTING OUT THE
VOLUMETRIC SURVEILLANCE
The function can be cut out (for ex-
ample, when pets are left in the car) by
carrying out the following operations
in rapid sequence. With the key at
MAR, turn the key to STOP, then
back to MAR and then back to STOP
again. Remove the ignition key. The
LED in front of the steering wheel will
light up for approximately two seconds
to indicate the function has been cut
out.
To restore the volumetric surveil-
lance function, take the key to MAR
and hold it there for longer than 30
seconds.
If you want to operate an electrical
device which runs when the key is at
MAR (e.g. the electrical window
winders) when the volumetric sur-
veillance function is cut out, turn the
key to MAR, operate the required
control and turn the key back to
STOP within 30 seconds. In this way
the the volumetric surveillance func-
tion will not be switched on again.
AUTOMATIC SWITCH-ON
(where fitted)
In some markets, the electronic
alarm can be programmed to be
switched on automatically.
The electronic alarm is automati-
cally switched on (without operating
the door locking system) after ap-
proximately 30 seconds from when
the car is left. This condition is de-
tected by the system by the following
sequence of actions:
– ignition key turned from MAR to
STOP;
– opening and closing of the last
door.
The automatic switch-on will be in-
terrupted if a door, the bonnet or the
boot is opened during the 30 second
timeout. The 30 seconds timeout will
start from zero after closure.
Press button C (fig. 8) on the igni-
tion key to switch the alarm off after
an automatic switch-on.
23