Lancia Lybra Owner's Handbook Manual page 124

Storing the speed
Move switch A to ON and take the
car to the required speed normally.
Turn ring B to (+) for all least three
seconds and release it. The car speed
will be stored and you can now re-
lease your foot from the accelerator.
The car will continue at constant
speed until one of the following events
occur:
– the brake pedal is pressed
– the clutch pedal is pressed.
IMPORTANT If required (e.g. for
overtaking) you can accelerate simply
by pressing the accelerator. The car
will return to the previously set speed
when the accelerator pedal is released.
Resetting the stored speed
To reset the stored speed after
switching the device off, e.g. by press-
ing the brake or the clutch pedal:
– accelerate progressively to reach a
speed which is close to the previously
set speed
– engage the gear which was en-
gaged when the speed was set (4th or
5th gear)
– press button C.
Increasing the stored speed
The stored speed can be increased in
two ways:
– by pressing the accelerator pedal
and storing the new speed (turning
ring B for longer than three seconds);
or
– by temporarily turning ring B to
(+): each turn of the ring will corre-
spond to a small speed increase (ap-
proximately 1 kph) while a continu-
ous pressure will correspond to a con-
tinuous increase of speed. Release ring
B: the new speed will automatically
be stored.
123