Controls - Lancia Lybra Owner's Handbook Manual

Rain sensor (where fitted)
The rain sensor is an electronic de-
vice combined with the windscreen
wiper which automatically suits the
flick frequency during operation to
the intensity of rain.
All the functions controlled with the
right-hand stalk (i.e. on/off, continu-
ous slow and fast wipe, temporary
fast wipe, windscreen washer and
headlight washer) are unvaried.
The rain sensor is automatically
switched on when the stalk is taken to
position 1 (fig. 107) and has the pur-
pose of adjusting the range of opera-
tion from stationary (no flick) when
the windscreen is dry to second con-
tinuous speed (continuous fast wipe)
when the rain is heavy.
When the windscreen washer is op-
erated and the rain sensor is on (by
taking the stalk to position 1), the
normal washing cycle is carried out
after which the rain sensor returns to
normal automatic operation.
118
The rain sensor is switched off when
the key is turned to STOP. It will not
come on again at the following engine
start-up (key at MAR) if the stalk is
at position 1.
Turn ring A (fig. 107) to set the rain
sensor sensitivity level:
AUTO = automatic sensitivity set-
ting
■ = low sensitivity
■■ = medium sensitivity
■■■ = high sensitivity.

CONTROLS

HAZARD LIGHTS (fig. 110)
These come on when switch A is
pressed regardless of the position of
the ignition key.
When these lights are on, the switch
and the ŸΔ warning lights on the in-
strument panel flash.
Press the switch again to turn the
lights off.
IMPORTANT The use of the haz-
ard warning lights is governed by the
traffic regulations of the country
where the car is being driven. These
laws should be complied with.
fig. 110