Lancia Lybra Owner's Handbook Manual page 30

to adjust the height of the front
and rear part of the driver's seat
and the rear part only of the passen-
ger's seat (control A);
¯˙ to adjust the seat back (control B).
Driver's seat lumbar adjustment
This device makes it possible to vary
back support and improve comfort.
Press the front part of the button C (fig.
15) to increase the support and the rear
part of the button to decrease it.
Heating (where fitted)
Press button D (fig. 15) to switch
the seat heating on. Press the button
again to switch it off.
fig. 15
The LEDs on the dashboard will
light up (A-fig. 16 = driver's seat, B =
passenger's seat).
Storing the driver's seat positions
(where fitted-fig. 17)
The system allows to store and recall
two different driver's seat and exter-
nal rearview mirror positions.
The seat and rearview mirror posi-
tion can only be stored when the ig-
nition key is at MAR.
Adjust the driver's seat position and
the external rearview mirrors as de-
scribed.
Press button "MEM" and either but-
ton "1", "2" or "3" corresponding to
each of the stored positioned at the
fig. 16
same time until two confirmation
beeps are heard.
The previously stored position will
automatically be deleted when a new
position is stored under the same but-
ton.
To recall a position, press the re-
spective button "1", "2" or "3" with
the door open. The seat will move au-
tomatically and stop when the stored
position is reached. A confirmation
beep will be heard.
IMPORTANT The lumbar adjust-
ment and the seat heating function
are not controlled by the stored seat
position system.
fig. 17
29