Charging The Smart Battery; Battery Life - VeriFone VX 680 Installation Manual

T S
ERMINAL ETUP

Charging the Smart Battery

Charging the
Smart Battery
NOTE
NOTE

Battery Life

WARNING
32
VX 680 I
NSTALLATION
If an application is loaded in the terminal, it starts after the initial VeriFone
copyright screen and usually displays a unique copyright screen. If no application
is loaded in the terminal,
VeriFone copyright screen.
After unpacking your VX 680 terminal, install the battery and connect the power
pack to the unit for 6 hours or until fully charged.
The VX 680 terminal's smart battery is also charged when the terminal is in the
Base Station. For more information, see
Station.
The smart battery has a safety circuit to protect the Li-ion cells from overcharging
and over-discharging. If the battery is over-discharged, the safety circuit shuts
down the battery. The battery must then be recharged to restore operation.
The VX 680 terminal automatically shuts off when the smart battery reaches the
critically low charge state. If this occurs, the smart battery must be recharged for a
minimum of 1/2 hour before it can power the terminal. It may take several
recharge attempts to reset the safety circuit when charging a smart battery that
has been discharged below this critical state.
The VX 680 smart battery can be charged and discharged hundreds of times, but
will eventually wear out. When operating times are noticeably shorter than usual,
it is time to buy a new battery (see
information).
Do not dispose of batteries in a fire. Li-ion batteries must be recycled
or disposed of properly. Do not dispose of Li-ion batteries in municipal
waste sites.
G
UIDE
appears on screen after the initial
DOWNLOAD NEEDED
Placing the Terminal Onto the Base
Accessories and Documentation for ordering