DataCard SR200 Installation Manual page 75

To set up IPSec security using a preshared key, do the following:
1.
Install the Status Monitor using a USB connection. Refer to "Installing the Status Monitor" on
page 55 for the steps to follow.
2.
Create a key.
a.
Using an application such as Notepad, create a text file for the key.
Allowed characters are upper and lower case letters (A–Z), numerals (0–9), and the

special characters hyphen(‐), underscore (_), open and close parentheses (), period
(.), comma (,), and the at symbol (@).
The key can be up to 255 characters long.

b.
Save the file with an extension of ".key".
3.
Open the Management Console by selecting Start > Run. Enter mmc in the Run dialog and
click OK. If needed, add the IP Security Policy Management snap‐in.
4.
Start IP Security Policy Management. This is available after IP security has been set up on the
PC.
5.
Open the Edit Authentication Method Properties dialog box for the policy.
6.
Select Use this string: and enter the key from step 1.
7.
Click OK to save the value and close the dialog box.
8.
Connect the PC to the printer with a USB cable.
9.
Open the Status Monitor as an administrator. Refer to the "Opening the Status Monitor"
section of the User's Guide.
10.
Power on the printer. Do not send any cards to print.
11.
Click the Printer Select tab. Do the following:
a.
Select IPSec Enable. Refer to the "Printer Select Tab" section of the User's Guide.
b.
Set the IPSec Type to Preshared Key.
c.
Click Details. The IPSec setting dialog box opens.
d.
Select Preshared Key from the Download Type list.
e.
Click Select. The Select Certificate Download File dialog box opens.
f.
Select Preshared Key from the Download Type list.
g.
Select the file and then click Write. The Status Monitor sends the file to the printer.
12.
Remove the USB cable connecting the printer and PC.
SR200 & SR300 Card Printers and LM200 & LM200 Laminators Installation Guide 67