If the printer is set to Network, and you plan to install the printer with a USB connection,
click Scan Printer if needed, and then change the value to USB.
You can use only one method (USB or network) to connect a printer.
If you plan to install the printer with a network connection, set up the network details,
including whether to use IPv4 or IPv6, automatic IP addressing (DHCP) or assigned
addresses, and address values if needed.
10.
Click Update to send the new information to the printer. The unit number
and printer name now correspond in the printer. You can verify all the
settings changed by viewing them on the printer LCD panel. Refer to the
"Using the LCD Panel Menus" section of the User's Guide.
11.
Disconnect the USB cable to separate the printer from the PC. Power off the printer.
12. Return to step
printers are installed.
If you plan to use any SR200 or SR300 printers from this PC, do not uninstall the Status
Monitor.
SR200 & SR300 Card Printers and LM200 & LM200 Laminators Installation Guide
3 to assign the unit number and printer name to the next printer, if multiple
61