Sanyo SPW-C1155DXHN8 Technical Data & Service Manual page 84

3. Timer Remote Controller
Sleeping Function (Continued)
If button does not work.
Or if the operation does not start even if
Check the following table.
Item Display of the remote control unit
1 The Error indication flashes
(for several seconds).
2
"This function is not available" indication lights up
(for several seconds).
3 Centralized control indication flashes
(for several seconds).
The sleeping function operation will be cancelled in the following cases:
1: When the unit is operated to stop or change the temperature setting by the other remote control unit or centralized control device.
2: When the unit is operated to stop or change the temperature setting with the weekly program function / outing function.
3: When the centralized control unit is prohibited from stopping the unit or changing the temperature setting.
1
Note
The temperature setting does not decrease (increase).
Operation under the sleeping function does not finish.
2
3
4
5
6
7
8
is pressed.
(Lighting/flashing indication)
Trouble
Control of W-2WAY ECO-i SYSTEM
The clock is not set.
When the operation mode is set to AUTO or FAN, this function is not
available.
The centralized control device is prohibited from starting/ stopping the
unit or change the temperature setting.
Possible Cause/Remedy
The temperature over the upper or lower limit or each operation mode
cannot be set.
Note if you change the time after the sleeping function started. The
operation does not finish until it reaches to the set starting time.
3-38
Contents